PDA

View Full Version : KT7A REV2 - MAJOR PROBLEMS :(



Pabby
04-21-2001, 05:36 AM
Ok, here's the deal.

I swapped out 2 sticks of Generic PC133 SDRAM with 2 sticks of 'Tonicom' PC166 SDRAM. After installing them, reconnecting everything, and restarting, I couldn't boot. I had to clear the CMOS, take the battery out, and let it sit for quite a while. Then, when it finally did boot, it would only run at 100x10; if I make any changes (hell, if I just go into the BIOS and leave without touching anything) it refuses to reboot. I have to clear CMOS *again* and I'm back to square one. On top of that, I installed the latest BIOS (dated 4/14/01), and, now, after I finally get it to boot at 100x10, and get into Win2k, when I exit Win2k and try to restart, I get 'Invalid CPU or CPU Changed -- Check Softmenu III' or similiar. So, I go and try to configure the correct parameters...and it does the same thing. Refuses to reboot. Any ideas?

Now, I've had nothing but problems with this MB since I've gotten it a few weeks back. I've ordered an IWILL KK266, and I'm real close to just tossing this KT7A PoS.

Chinpoko_Mon
04-21-2001, 05:47 AM
how long have you had the board? perhaps it's an isolated incident, then in which case, you should send it back for a new one...

I've had mine for 2 mths now...Was using some generic RAM b4 and from time to time, it would freeze up on me or crash. But since putting my new Crucial mem it's been smooth as a baby's bottom.

best of luck....