renovation

i just got a set of klipsch cs-300 2.1 speakers for my rig. they come with 2 satellite's and a base and remote controller .i got a extra 2 controls anyway thats nothing and not the problem . theres also a a unit called a virtual speaker . here is were im at .this may be a bit hard to follow so i go step by step below .

1ST ran right and left speaker wires to the base and satellite speakers with leads supplyed by klipsch.

2nd ran the power lead feed from the base to the virtual speaker unit that sits on the desk !

3rd attached the dual feed cable with red and white male adapter ends from the virtual speaker box thats on my desk but used a 2 adapter male wire using gold barrow connectors to a dual male lead with one single male on the other end .

4th i connected this wire to the green input jack on my sound card (the input jack )

im not getting any sound from my computer . any ideas what i should do ?

im running windows xp .and this is onboard sound on the mother board .
i do have a sound blaster live card i could install .
but i know how ever /what ever i do for speaker wires im going to have to use barrow connectors or hit radiocrap and see if they have 2 strands of leads with a both male ends .but the one's that connects to the virtual speaker box. need to be the large head type that go into the unit and wrap around the imput addapter !.
what you guys think .
ps.i checked klipsch web sight and not found a listing for this computer speaker setup .it did come from there product development unit .

__________________
You could pick up Lindsay Lohan for less than a intel 990x, and still have money left over to bail her outta jail

renovation

had to run out and buy the right jumper cord .the one i was using from my camcorder would not work ~