08-03-2002, 03:58 PM
|
#1 |
|
Lieutenant Junior Grade
 Join Date: Jul 2000
Posts: 62
|
Front USB Question
finally got a case w/ front usb & was wondering how to connect it to the mb. theres 4 wires for each usb port: black (GND), yellow (USB1+), green (USB1-), and red (VCC)
would i put the connectors on the same as i would with one of these:  the only diff is that one my usb wires from the case is yellow & on this mb cable, the wire is white...so i dont know if i would put it on the same or not. Probably a dumb question but i just wanted to be sure  if it helps, i have an abit SA6R |
|
|
|
08-03-2002, 04:20 PM
|
#2 |
|
Vice Admiral
  Join Date: Dec 2000
Location: ohi
Posts: 4,525
|
On the soltek SL-75DRV5, there is a 5x2 set of pins (actually 9 pins because there's no pin in lower right) labeled USB3 near the AMR slot.
| | | | | | | | | The red wires on your little pluggy things should touch the first column of pins. Last edited by irwin : 08-03-2002 at 04:24 PM. |
|
|
|
|
08-03-2002, 05:37 PM
|
#3 |
|
Lieutenant Commander
Join Date: Jun 2000
Posts: 532
 |
DAMN pass..aint you the super nasty HW freak...
~sim |
|
|
|
Linear Mode
