Results 1 to 2 of 2

Thread: anybody own an Eagle Summit?

  1. 07-20-2002, 03:54 PM #1
    BigJon
    BigJon is offline
    Vice Admiral BigJon's Avatar
    Join Date
    Sep 2000
    Location
    In the kitchen...skinning onions...
    Posts
    4,954
    Send a message via AIM to BigJon Send a message via MSN to BigJon Send a message via Yahoo to BigJon

    anybody own an Eagle Summit?

    If so, after pulling off the calipers...how are the rotors attached? Do they just fall off? Are they held on by alignment screws? Do you have to back the hub nut off to get it off? I need to know if this is going to be an easy or hard job...
    Reply With Quote Reply With Quote
  2. 07-20-2002, 04:35 PM #2
    Nanotech9
    Nanotech9 is offline
    Vice Admiral Nanotech9's Avatar
    Join Date
    Feb 2000
    Location
    Gone Wheeling!
    Posts
    4,409
    in general....

    most rotors have a little counter-sunk bolt that holds the rotor in place to the hub... When you bolt the wheel on, thats what REALLY holds the rotor in place.

    you Shouldnt have to loosten the hub nut - thats a no no.

    you will PROBABLY have to use a hammer and a block of wood to tap the rotor off the hub once you've removed the little bolt that holds it in place...

    last time i did rotors, i had to tap pretty hard to get them off.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules